State guide · Maryland

Maryland tap water and PFAS by utility: WSSC Water, Baltimore City and the state's study

What WSSC Water and Baltimore City report for PFAS, what 'above 4 ppt' does and doesn't mean, and what MDE's statewide study found in public water systems.

By Tap Tested editorial team · Updated · 6 min read · How we check facts

The short version. Maryland's two largest water utilities report PFAS at low levels in 2025: at or under 4.2 ppt for PFOA and PFOS in WSSC Water's two plants, and at or under 3.3 ppt in Baltimore City's two.[1, 2] EPA's limits (4.0 ppt each) are not yet being enforced (compliance determinations are scheduled to begin April 26, 2029), and EPA says compliance will be judged on running annual averages.[1, 5] The bigger PFAS story in Maryland is in small groundwater systems and private wells, where the state's own study found far more detections.[3]

WSSC Water (Montgomery and Prince George's counties)

WSSC Water serves 1.9 million customers. It treats water from the Potomac River (Potomac plant) and from the T. Howard Duckett Reservoir on the Patuxent River (Patuxent plant), and has monitored PFAS at both plants since January 2020.[1]

2025 annual report. The "tap" results table lists:[1]

PFASPatuxent: highest (range)Potomac: highest (range)EPA limit
PFOA1.8 ppt (<1.6 to 1.8)3.7 ppt (1.8 to 3.7)4.0 ppt
PFOS1.8 ppt (ND to 1.8)4.2 ppt (1.9 to 4.2)4.0 ppt
PFHxS1.6 ppt (ND to 1.6)1.9 ppt (ND to 1.9)10 ppt
PFNAND1.7 ppt (ND to 1.7)10 ppt
PFBS2.0 ppt (<1.6 to 2.0)3.0 ppt (2.4 to 3.0)Hazard Index only

The Potomac plant's highest PFOS result (4.2 ppt) is above 4.0 ppt, so it deserves a careful reading. WSSC's report marks the "violation" column "N/A" and explains that MCL compliance determinations are scheduled to begin April 26, 2029.[1] WSSC also explains that it reports both single results and the running annual average (the average of the most recent four quarters), and that, under EPA rules, a result below the practical quantitation limit (4 ppt for PFOA and PFOS) counts as zero in that average even though a trace may be present.[6]

Recent quarters, as listed on WSSC's PFAS page (we read the page on Nov. 19, 2026; its footer says "as of April 2026" even though it lists later quarters, so check it for updates):[6]

QuarterPotomac PFOAPotomac PFOSPatuxent PFOAPatuxent PFOS
Q4 20242.82.12.3<1.7
Q1 20251.81.91.8ND
Q2 20253.74.21.7<1.6
Q3 20252.63.61.71.8
Q4 20252.31.9<1.7<1.7
Q1 20261.92.22.0<1.6
Q2 20262.02.51.8<1.6
Q3 20263.05.12.01.6

All figures are ppt. Over the whole series since 2020, the highest single results on the page are 5.3 ppt (PFOA) and 6.2 ppt (PFOS) at the Potomac plant (both in Q3 2022), and 2.4 and 2.6 ppt at the Patuxent plant.[6] On WSSC's running-annual-average basis, which is the basis for compliance, the Potomac plant's PFOS value was 1.3 ppt as of Q3 2026 and PFOA 0.0, against 4 ppt limits; the Patuxent plant's were 0.0.[6] The Q3 2026 PFOS result of 5.1 ppt is above 4.0 ppt for that quarter, which is why single results and running averages are reported separately.

Baltimore City Department of Public Works

Baltimore City DPW serves 1.8 million customers. Its water comes primarily from the Liberty, Loch Raven and Prettyboy reservoirs, with the Susquehanna River used only in severe drought, and it treats water at the Ashburton and Montebello plants.[2]

2025 report. The report lists PFAS results for the two plants (limits are scheduled to take effect April 26, 2029):[2]

PFASAshburton: highestMontebello: highestEPA limit
PFOA2.9 ppt1.9 ppt4 ppt
PFOS3.3 ppt1.7 ppt4 ppt
PFBS1.8 ppt2.2 pptHazard Index only
PFHxSNDND10 ppt
PFNANDND10 ppt
Hazard Index (PFBS + PFHxS + PFNA + GenX)0.00090.0031.0

The report says Baltimore's UCMR 5 sampling (August 2024 to May 2025) found no constituents above the program's minimum reporting levels.[2]

Other items in the same report. For lead, 90% of tap samples were below 2.74 ppb, none exceeded the 15 ppb action level, and the range was <2 to 7.09 ppb; the next compliance round is in 2027.[2] The report also discloses a reporting violation: Baltimore's certification of customer notices about service lines classified as lead, galvanized requiring replacement, or unknown was late, because about 73,000 notices were left out of the original mailing, which the City attributes to a suspected data management error. The notices were mailed on November 25, 2024.[2]

What MDE's statewide study found

Between September 2020 and 2025, MDE ran a five-phase study that analyzed 1,880 samples from 877 public water systems, including raw and finished water. PFAS was detected in 827 samples (44%), and 20.2% of samples had at least one PFAS above its limit or a Hazard Index above 1.[3] The details matter more than the totals:

  • Source type drives the results. Unconfined-aquifer groundwater had PFAS detected in 72.3% of samples, confined aquifers 3.2%. Only one surface-water system had a limit exceedance.[3]
  • Geography matters. Most systems above the limits were in the fractured-rock region (west of the Fall Line, roughly along I-95); in the coastal plain, all systems above the limits had one or more shallow, unconfined sources.[3]
  • PFOA was most often above its limit: 17% of samples exceeded 4 ppt.[3]
  • The highest single results were 270 ppt PFOS (Carroll County), 173 ppt PFHxS (Frederick County) and 919 ppt PFOA (Baltimore County), all in the fractured-rock region.[3]

Caveats from MDE's own report: 97% of samples came from groundwater sources, many were raw (untreated) water, and most Maryland systems at the time would not have been expected to remove PFAS.[3] These are counts of samples, not of violations, and the federal limits are not yet enforceable.[1] Most Maryland public water systems are small groundwater systems, but most residents are served by a few large surface-water systems, which is why the big utilities look so different from the state average.[3]

What the federal rules say right now

EPA finalized limits for six PFAS in April 2024, including 4.0 ppt each for PFOA and PFOS. Initial monitoring is due by 2027 and any reductions by 2029. In May 2026 EPA proposed to keep the PFOA and PFOS limits with an option to request two more years, and to withdraw the limits for PFHxS, PFNA, GenX and the Hazard Index. These are proposals, not final rules.[7] EPA's UCMR 5 data are not compliance determinations; you can look up any system in EPA's Data Finder.[5, 8] Note that both utility reports above were written before the May 2026 proposals.

If you are on a private well

None of these utility numbers apply to a private well. MDE's own private-well fact sheet says wells are not regulated, that owners should test at least annually, and that only a limited number of certified labs can test for PFAS.[4] Given MDE's study findings, which are about public-system wells, we think shallow wells in the fractured-rock region are worth a PFAS test. That is our inference, not an MDE statement. See our Maryland well water testing guide.

How we built this page: see methodology and sources. Spot an error? The about page has our contact address.

Frequently asked questions

Does Maryland tap water have PFAS?
The two largest utilities report low levels: WSSC Water's 2025 report shows PFOA up to 3.7 ppt and PFOS up to 4.2 ppt at its Potomac plant, and Baltimore City's report shows PFOA up to 2.9 ppt and PFOS up to 3.3 ppt (WSSC Water, Baltimore DPW). MDE's statewide study found PFAS in 44% of samples, mostly from groundwater in unconfined aquifers (MDE).
Is a result above 4 ppt a violation?
Not by itself. WSSC's report notes that PFAS limit compliance determinations are scheduled to begin April 26, 2029 (WSSC Water), and EPA says compliance will be judged on running annual averages of quarterly compliance results (EPA).
How do I find out about PFAS in my own water?
Start with your utility's annual water quality report. For Maryland utilities, MDE hosts the reports, and EPA's UCMR 5 Data Finder lets you look up results by system (EPA). If you are on a private well, see our Maryland well water testing guide.

Sources

Every factual claim above links to one of these. Accessed November 18, 2026 unless noted.

  1. 2025 Water Quality Report: Excellence Expanded, Safeguarding Every Sip — WSSC Water.
  2. 2025 Water Quality Report (Baltimore City, as hosted by MDE) — Baltimore City Department of Public Works.
  3. Summary Report for MDE's PFAS in Public Drinking Water Study (April 2026) — Maryland Department of the Environment.
  4. PFAS in Private Drinking Water Wells (factsheet, March 2023) — Maryland Department of the Environment. Written before EPA finalized its 2024 PFAS rule; it refers to the then-proposed limits.
  5. Fifth Unregulated Contaminant Monitoring Rule (UCMR 5) — U.S. EPA.
  6. PFAS Test Results — WSSC Water.
  7. Per- and Polyfluoroalkyl Substances (PFAS): Final PFAS National Primary Drinking Water Regulation — U.S. EPA. Page last updated May 18, 2026; describes the 2024 rule and the May 2026 proposals.
  8. UCMR 5 Data Finder — U.S. EPA.

Affiliate disclosure: some links to products or services on this site may be affiliate links. See our disclosure. Recommendations follow independent certification, not commissions.